The function of a compressor control system is to regulate the amount of air moving out of the tank. In the past, this control was supplied by an electro-pneumatic valve that cut off airflow when electric current was discontinued. Modern control is provided by a microprocessor and software. Whichever type of control system present they can be placed into one of two categories: fixed speed or variable-speed control...
Cables pinion rack steering (teleflex) installation
Much like an automobile requires the functionality of the entire steering system to be effective and avoid potential hazard, the same is true for the steering system of a river boat. A rack and pinion steering cable in a river boat should be checked approximately every three months to investigate damage such as rust or weak points. Additionally, it should be inspected if there is a resistance in the wheel.
More often than not, failed steering in a boat can be attributed to a damaged cable. If you are having trouble steering, don't let that keep you off the water. The installation of a boat rack and pinion steering cable, such as Teleflex, is relatively simple and requires a very small amount of time, a box wrench, and – of course – a steering cable. Oh yes, and you may need a helper.
Here is a step by step guide to help you with the installation of your steering cable. Before you start, remember to protect your upholstery with some plastic covering, as you may incur an oil spill.
Step 1
To gain access to the muffler, currently installed rack & pinion steering cable and drive shaft, lift the boat's floorboard. Locate the rudder (the directional stem) – which may be made of fiberglass, wood or metal – and lift the cable from the top. With your eyes, follow the length of the cable past the ski locker and gasoline tank, which is where you will find the other end of the cable. Yes, there are a few obstacles in your way, but you can remove them.
Step 2
To begin clearing the path to the other end of the steering cable, use your box wrench to remove the bolt from the wall of a fastener with a bow-like appearance. Pull the rudder arm forward, and unscrew the center nut on the steering connection and the top bolt.
Step 3
Move the driver's seat as far out of your way as it can possibly go and crawl under the dashboard of your boat. There will be a long rectangular bar with rack-and-pinion assembly connected to the steering column. You will most likely have to remove 4 bolts until the assembly piece is free.
Step 4
You may need to remove the kick board, heater, or stereo equipment to gain access to the path of the old steering cable. This is where a partner will come in handy. It is time for you to get to the end of the trail and replace the cable. Ask your partner to hold the opposite end of the old cable as you remove it.
Step 5
After comparing the cables as a final validation you have the right size, have your helper hold one end of the new cable as you replace the old. Reinstall the parts you removed as you guide the cable back through, reinstall the assembly and attach your new cable to the rudder.